Blinker / Flasher location and Part Number wanted

Replies to This Discussion

Permalink Reply by Ryan Zmolek on July 5, 2009 at 10:25pm

Id like to know the same thing. Have you found part number or anything so that electronic flasher units can be used? I've had very little luck...

▶ Reply to This

Permalink Reply by FIATman on July 6, 2009 at 10:13pm

Check these folks. Your question got me searching. It was a quick find. I am thinking of the same problem for my vehicles and figured all these trucks on the highway with LED lights have solved the problem.
http://www.grote.com/prodcat/H.html I googled "solid state turn signal flasher"

▶ Reply to This

Permalink Reply by FIATman on July 7, 2009 at 5:11pm

Have you tried the LEDs without changing anything? From info I found, there are two relays, one each for the left and right turn-brake light circuit. If these relays that light the lamps and are run by a flasher circuit of some sort, then the load of the "lamp" doesn't matter. I am betting you might not need to change the "flasher". BTW where did you get the LEDS? Who made them? Thanks for any info.

▶ Reply to This

Permalink Reply by 451 Kahn on July 9, 2009 at 1:45am

Check ebay

▶ Reply to This

Permalink Reply by Andrew Forrest on August 15, 2009 at 8:41pm

Hey Ned,
I'm doing the same thing. The two flasher relays are located at the back of the SAM (fuse box).in a seperate harness. I have so far been unsuccessful in finding an electronic equivalent however and may have to resort to a load equalizer.

▶ Reply to This

Permalink Reply by Zippin Pippin on August 30, 2009 at 1:31am

Have you looked at www.superbrightleds.com
They have some really nice products for interior lighting as well as a wide array of automotive bulbs and electronic flashers suitable for use with leds.

▶ Reply to This

Permalink Reply by Tony 1 day ago

I've looked for LED's online but don't seem to find any that match the unusual bulb numbers in the Smart owners manual. Who is the source you've used to find the bulbs? I also would like to change out the ones in my dash, clock and tach.

▶ Reply to This

Permalink Reply by FIATman 1 day ago

Everyone in this thread needs to get more familiar with the smart's circuitry BEFORE futzing with it. I, for one, have not even found a good electrical diagram, have you? As far as I can determine from calling a dealer service guy, and observation in my car, the turn signal lamps are not "flashed" by a flasher as most of us think of it. It seems to get a flash signal from deep in the SAM which actuates a RELAY, which is not a "FLASHER". I have found out that most of the dash illumination is by LED already. The evilution site talks about them. I also wonder WHY regular bulbs need to be changed out if they aren't burned out. I have a 2001 Ford Focus which still has all of its original bulbs with the exception of the number plate lamp. Are you guys really "saving" anything?

▶ Reply to This